Old style tooling tended to pull the hand in to the cutters, often resulting in serious amputations. Although limited cutter projection tooling will not prevent an accident it is designed and constructed to significantly reduce the extent of an injury if the worker touches the cutters. If injuries do occur they are likely to be lacerations requiring stitches rather than amputations.

Risk of ejected cutters from square block as well as serious hand injuries when no chip limitation:

An example of limited cutter projection tooling for use on a hand fed machine (marked MAN on tool body). This cutter block has chip limitation from a dummy profile as well as secure fixing arrangements for the blade to prevent the risk of ejection, this being two side bolts and centre bolt for a locking wedge.

The limiter reduces the depth of cut so 'kick backs' are less likely to occur.

Ejection of the tools was common with the old style cutters as they were only held in place by the friction from clamping bolts. Chip limited tooling has two ways of securing the cutters, preventing ejection.

The reduced depth produces a better finish, so less sanding is required, reducing the health risk and improving production.

Chip limited tooling is much better balanced so there is less vibration when it runs. This has the following benefits:

The old style tooling requires a lot more skill and time to set up correctly. Chip limited tooling is simpler to set up and therefore reduces down time during changeover. Also, as it is more likely to be right first time less timber is wasted. One head can also have several different profiles which also reduces set up times.

These hand-fed machines should have been fitted with limited cutter projection tooling after 5 December 2003:

For more information visit the Tooling for use with hand-fed woodworking machines WIS37(Revision 1) website.

HSE aims to reduce work-related death, injury and ill health.